New Mobile Bench Project

by hansmeevis on September 15, 2010

 Many years ago I had a mobile jewellery workbench that included everything that is necessary in a basic workshop to make jewellery.
Melting, rolling, fabrication and polishing.
I described it Here


Unfortunately my workshop was reduced to ashes by a fire that was started by the hotel staff where I was situated at the time.
My bench is at the bottom left.
Anne and I have for the last two years been wanting to leave this island and the time has now come for me to pull finger and build another mobile bench.

So we start. I buy a few lengths of 30mm x 30mm x 2mm square tubing and some 25 x 25 mm x 2mm square as well.

Then I cut the 30 mill tubing and weld this shape up.
Length 1260mm
Depth 700mm.
Center bar 600mm.

Depth of center bar 360mm
I make two of these .

Sorry, the only picture I got of both, somewhat further into the work than the above picture shows. ( I get hung up )

Anyway, now I tack on some 30 mm square, 50 mm high on each corner .
I’ll weld it properly later, but for now I just want to get everything nice and square .
( tacking allows for tap adjustment. )

Like this.

This is to fit a 25mm sq length into it.
The reason I go to this effort is because I want to be able to take this thing apart, so it is easier to transport or to get up stairs or narrow doorways.
Like that.

The basic structure, tacked together.
Height is approximately 925mm.
Two afternoons work gets me this far.
This is the easy part.
The finicky stuff comes later.
I anticipate this project to last three months.
I will be posting as I go along.
Along with the jewellery I am still making.
I am going to make a dedicated blog and cross post just for this project, otherwise it will be too disjointed, what with all the other junk I post here.
You just never know, someone might want to build one as well. Ha ha.

hansmeevis

hansmeevis

hansmeevis

Latest posts by hansmeevis (see all)

{ 4 comments… read them below or add one }

Jane Walker September 17, 2010 at 12:08 am

Oh, Hans … where are you off to? I envision you sailing from your island home, mobile bench firmly bolted to the stern. Of course, you’ll have to have a little dark shielded area for your soldering station …
Maybe you’ll end up sailing to Perth, Australia to pay me a visit!!

Reply

Karen Sutton September 16, 2010 at 3:25 pm

I’m so glad you decided to make another one. I fell in love with that work bench when I read the post, and was devistated for you when I got to the part about it being destroyed. I’ll be watching this one evolve!

Reply

Beth Wicker September 16, 2010 at 6:29 am

Have you decided where you are going and when? Will be interested to see the mobile bench progress… I have a purchased small desk top bench that I take to craft shows, but it would not work for a full time bench – too small.

Reply

Ruth Shapiro September 16, 2010 at 12:48 am

Great instructions-thank you for sharing so generously! Can’t wait to see the next steps!
Ruth Shapiro

Reply

Leave a Comment

Previous post:

Next post:

WordPress Admin