Jigs and Dies

by sheltech on February 7, 2011

bezel forming jigs for 22 ga., 1/4″ tall copper bezels . the bezels are intended to fit on top of parts cut from existing blanking dies . I made a separate die to cut parts slightly smaller than the existing parts, and soldered a stck of them together , about 3/8″ tall . these are screwed to the 1/2″ thick aluminum base plate . 3/32″ dia. holes are strategically placed in the base plate, to accept steel pins that aid in forming the bezel by keeping it where you put it, in certain places , basically.

sheltech

sheltech

sheltech

Latest posts by sheltech (see all)

Leave a Comment

Previous post:

Next post:

WordPress Admin