[Jewelry making - Article 00591] - [Orchid] Ney Vulcan 550 - help

[Darcy Brockbank]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I lost my manual for this... I've figured everything out except how
    to link programs together. 

    Each program has three temperature steps. So, in order to do a four
    temperature burnout cycle (300F, 700F, 1350F, then casting temp), you
    need to "link" programs. 

    I cannot for the life of me figure out how to do this. 

    Does anyone out there know? 

Thanks,
- darcy

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________