[Jewelry making - Article 00599] - Re: [Orchid] Flexshaft questions

[Ken Kotoski]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello Tato and Timothy, Timothy is right about the uses of the
    flexshafts and handpieces. I would like to clear up one mistake about
    the foot pedals. The 'curcuit board' style are no longer available and
    to repair them they now have a trigger switch. The switch takes a
    bracket to hold it in place. You can no longer get the curcuit boards
    of foot pedals with them in it. 

    There are those that liked the curcuit boards over the trigger switch
    and those that like the trigger switch over the curcuit board. The
    nice thing about the curcuit board was if you did bend the twisted
    wire part you could get replacements for next to nothing. Now with the
    switches it is basically the only part and when it goes it's much more
    expensive. 

Ken Kotoski
MPG Repair
www.mpgrepair.com 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________