My name is Ed Retherford, and I am completely self taught in jewelry repair, design, and construction, as well as watch repair, and have been at the bench since I was 12 years old (now 49). My wife and I have a small mom and pop sized store in Kokomo Indiana for the last 20 years.

Attached is a single picture with a set of Monopoly tokens that I made for myself. I handcarved all the wax models for each piece, then had Larry Paul Casting cast them all in solid 18k gold for the tokens, and sterling silver for the houses and hotels. To the best of my knowledge there is no other 18k set in the world. I have found that Henry Dunhils of Londonhad a German goldsmith makea 9k set in the 1930's, but hasnt been seen since anunknown buyer took delivery at the time of completion. Also, a jeweler in Florida made a set in 14k a few years back, and I believe that he still has possesion. There are actually 6 houses and 6 hotels, but I only placed 1 of each in the photo. After getting the raw castings back from LP, then I hand finished each piece. This set of tokens is modeled after a real set from the late 1930's that my uncle gave me. It would have been much simpler to make rubber molds from the original tokens, but that would be cheating wouldn't it now? Instead, I chose to carve them over the course of a couple years, in my spare time from my busy retail shop. I made slight differences in the detail of each piece from the original tokens so that I canshow that I waxed these rather than made rubber molds from the originals. For instance, I placed a different style of hat on the horse jockey, and shingles on the roofs of the houses and hotels, and varied the wrinkles in the leather of the boot. But I made sure that the details would be imperceptible unless compared side by side with the original pieces. Someday when I get a little spare time again, I plan on setting diamonds for headlights and hubcaps on the car, and in the dimples of the thimble, and maybe filling the wheelbarrow with diamonds and colored stone melee. Incidentally, I am looking for suggestions on a way to set the stones into the wheelbarrow so that they maintain a piled or jumbled appearance but still remain stable. I have even acquired all the materials for making a playing board in sterling and matching walnut, but just cant seem to find the time to get it started. The walnut bases for each token were made by a kindly old retired gentleman who is a customer in my store, who simply wanted to be a part of this project. His quality woodworking abilities have been greatly appreciated. Photography and photo editing done by myself.